Bloomfield 1016BVM Spezifikationen PDF herunterladen (Seite 8)

1016BVM OPERATION

START-UP

For initial start-up, or if the brewer has not been used for an

extended period of time:

• Be sure spray disk and brew gasket are properly installed in the

brew head.

• Be sure the water supply is properly connected and the water supply

valve is turned ON.

• Be sure the WATER TANK IS FILLED.

IMPORTANT: Fill the water tank before energizing this unit:

Insert the brew chamber (empty) and place an EMPTY decanter in

place under the brew chamber.

Connect unit to electric power. Four beeps will sound and all lights

glow momentarily.\

Be sure the brewer is “off” (if necessary, press ON/OFF key until

no LEDs are lit).

Press BREW key three (3) times, then press CANCEL key once.

BREW and HEAT indicators will ash while tank is lling.

When water starts to ow from the brew chamber, the tank is full.

Press ON/OFF key once to terminate ll. Heating element will be

energized and will begin heating water in preparation for the rst

brew. When the water has reached the proper temperature, the

HEAT light will go out.

IMPORTANT:

Tank must be full of water

before pressing POWER

key “on”. Heating

elements will be damaged

if allowed to operate

without being fully

submerged in water.

Damage caused by

operating the brewer

without water in the tank

is NOT COVERED BY

WARRANTY.

Fig. 3 Brewer Operation Diagram

To Fill Tank, Press

BREW—BREW—BREW—CANCEL

912 p/n 2M-75936 Owners Manual 1016BVM Coffee Brewer

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Keine Kommentare

Bloomfield 1016BVM Spezifikationen Seite 8